Skip to content

Bonded and insured, $2 million coverage. Free quote: (714) 361-9316

Garden Grove · Santa Ana · Orange · Westminster

(714) 361-9316

ServicesSliding Door Replacement

Sliding Door Replacement in Garden Grove

A sliding door that drags, leaks air or fogs between the panes usually has a specific cause. We find it, tell you plainly whether the door needs to come out, and if it does, install a new unit that glides, locks and seals the way it should.

Installer in gloves positioning a tall sliding glass door panel into the back opening of a beige stucco house, with a concrete patio, ladder and tool bag nearby

When a new sliding door is the right call

Not every stubborn slider needs to come out. A door that drags is often just dirt packed into the track or worn nylon rollers, and we will say so up front, ahead of any talk about a new unit. A new door makes sense when the frame itself has failed: a bent aluminum track, a corroded sill, a broken seal between the glass panes, or an old single-pane door that sweats and lets heat pour in all summer.

Plenty of houses in the area built in the postwar decades still carry the aluminum sliders they came with. Bare metal frames pass heat and cold right through to the inside, and a single sheet of glass does almost nothing against strong afternoon sun. A modern vinyl frame with insulated, tempered glass changes how that room feels, and the panel moves with one hand again.

We are an authorized Crystal Pacific Windows installer. Our company is bonded and insured with $2 million in coverage, which matters on a job where a large, heavy glass panel is being carried through your home.

Low-angle view of a worker kneeling on a wooden back deck, writing on a clipboard beside a weathered patio door with peeling white paint on a stucco house

What a new sliding door includes

  1. 01

    Removal of the old unit

    We lift out the old panels, cut the frame free and pull it without tearing up the surrounding stucco or drywall where we can avoid it. The old door is hauled away.

  2. 02

    Retrofit or full-frame install

    If the existing opening is square and solid, a retrofit frame fits inside it and leaves the stucco alone. When water has softened the sill framing or the opening has racked over the years, we strip it back to the studs and rebuild it so the new frame sits on solid wood.

  3. 03

    Tempered dual-pane glass

    Door glass must be tempered by code, so it breaks into small pellets instead of sharp shards. We pair it with Low-E coatings that cut the solar heat coming through the panel.

  4. 04

    New rollers, track and lock

    The new unit comes with adjustable stainless or ball-bearing rollers, a fresh track and a multipoint or keyed latch. We set the rollers so the panel tracks evenly and the interlock closes tight.

  5. 05

    Sill pan and sealing

    Water that gets past a sliding door collects at the sill. We set the new frame on a sloped sill pan or flashing, then seal the perimeter so rain drains out instead of into the subfloor.

  6. 06

    Trim and cleanup

    We finish the interior and exterior trim, adjust the screen and vacuum the work area at the end of the job.

Questions about Sliding Door Replacement?

Call(714) 361-9316

Signs your sliding door is ready to retire

  • Fog between the panes

    Haze or droplets trapped inside a dual-pane unit tell you the spacer seal around the glass has broken down. Once that happens the insulating argon has leaked out, and no amount of cleaning brings the view back.

  • The track is bent or pitted

    New rollers cannot ride smoothly on a dented or corroded aluminum track. When the track is part of the frame, the frame has to go.

  • Drafts and whistling

    Worn pile weatherstripping and a frame that has racked out of square let air through the interlock. You can often feel it at the bottom corners.

  • The latch will not catch

    If the panel no longer lines up with the keeper, the frame may have shifted. A door that will not lock is a security problem, not just an annoyance.

  • Condensation on the frame

    Water beading on an aluminum frame on cool mornings shows the metal is carrying cold indoors, and that moisture can stain and rot the flooring below.

How the job runs

  1. 1

    In-home estimate

    We look at the door, the track and the sill, measure the opening and tell you whether a new door is actually needed. The estimate is free, with no sales pressure or obligation.

  2. 2

    Ordering the unit

    Sliding doors are built to the measured size, so we confirm the panel configuration, which side operates, the frame color and the glass package, then place the order.

  3. 3

    Installation day

    Most single doors come out and go back in on the same day. We lay drop cloths, protect the floor, set the new frame level and plumb, and seal it on a sill pan.

  4. 4

    Adjust and walk through

    We tune the rollers, check the lock and screen, and have you open and close the door yourself as the final check.

What affects the cost of a new sliding door

The price depends mostly on the size of the opening, the frame and glass you pick, and what turns up under the old sill. Your quote is written line by line so you can see where each dollar goes. The in-home estimate itself costs nothing.

Size and panel count
A standard two-panel door costs less than a wide three- or four-panel unit, which needs heavier glass and more hardware.
Frame and glass package
Vinyl, color options, Low-E coatings and laminated glass each change the price. We explain what each one does so you only pay for what helps.
Retrofit versus full-frame
A retrofit leaves the stucco intact. A full tear-out adds stucco patching and trim work, which adds labor.
Condition under the sill
Years of water getting past an old door can soften the subfloor. If we find damage, we show you photos and get your OK on any added work.

Sliding door questions

My door just sticks. Do I really need a new one?

Maybe not. Sticking is often a dirty track or worn rollers, and we will tell you that during the estimate. A new door is what we recommend only when the frame, track or glass seal has failed and new parts would not fix it.

How long will my doorway be open?

For a typical retrofit, the opening is usually closed up again the same day. Full-frame jobs with stucco work can take longer, and we give you the expected schedule at the estimate.

Will you damage my stucco?

A retrofit install does not disturb exterior stucco at all. If the opening has to be rebuilt, we cut back only what is needed and patch it.

Can I go wider or switch to a folding door?

Widening an opening means changing the header, which is a bigger structural job. If you want a fully open wall, ask about our multi-folding doors during the estimate.

Will a new slider make the room cooler?

Usually, yes. A Low-E coating on dual-pane glass bounces a large share of solar heat back outside, so less of it warms the floor and furniture. Vinyl also does not conduct heat the way bare aluminum does, and a tight interlock with new weatherstripping stops the drafts that let cooled air leak out.

Find out what your sliding door actually needs

We will check the rollers, track, glass and sill and give you a straight answer. If a new door makes sense, you get a clear written quote.