Skip to content

Bonded and insured, $2 million coverage. Free quote: (714) 361-9316

Garden Grove · Santa Ana · Orange · Westminster

(714) 361-9316

ServicesWindow Replacement

Window Replacement in Garden Grove

We put new windows in where the old ones have actually failed: fogged dual-pane glass, warped or corroded frames, sashes that no longer seal. Every opening gets its own inspection, and if a window still has years left in it, we tell you and leave it off your quote.

Installer in cap and tool belt, seen from behind, pressing a new white double-hung window into a brick wall opening on a single-story home

When a new window is the right call

A window is a system: the frame and sill, the sash, the insulated glass unit and the seals that hold it all together. A new unit makes sense when one of those parts has failed and can't be put right at a sensible cost. Think of a broken edge seal that lets moisture fog the space between panes, a frame that has bowed out of square, or an old aluminum slider whose single pane lets summer heat straight into the room.

Plenty of windows look tired but still do their job. A slider that drags may only have a dirty track or worn rollers, and loose weatherstripping causes many drafts. When that's what we find, we say so plainly and that window stays out of the estimate. Six windows that truly need new units are a better project than twelve sold as a whole-house package.

Many homes in Garden Grove still have their original aluminum-frame windows, and those are usually where new dual-pane glass makes the biggest difference in comfort and street noise.

What the work includes

A window-by-window assessment

We check each frame for square, each sill for corrosion or rot, each glass unit for seal failure, and how every sash opens and locks. You get a written line-item estimate showing which openings we recommend swapping out and the reason for each one.

Retrofit or full-frame, chosen per opening

Most stucco homes take a retrofit insert that sits inside the existing frame, so the stucco stays intact. Where the old frame is damaged, we remove it down to the rough opening and set a new nail-fin window with fresh flashing and a stucco patch. Our Window Retrofitting page covers the insert method in more detail.

Crystal Pacific windows, properly installed

We are an authorized Crystal Pacific Windows installer. That means vinyl frames with welded corners and dual-pane glass with Low-E coating options, set the way the manufacturer specifies.

Sealing, flashing and drainage

Each window is shimmed level and plumb, the gaps are filled with low-expansion foam, and the exterior gets a sealant made to bond with stucco. We keep the weep holes in the bottom track open so rainwater drains out instead of into the wall.

Permit and energy code paperwork

When the city requires a permit, we pull it. The glass we specify meets California energy code values for U-factor and solar heat gain, and we leave the rating labels on until inspection.

Haul-away and cleanup

Old frames and glass leave with us. We lay drop cloths inside, vacuum the sills and tracks, and wipe down the new glass before we go.

Low-angle view of a worker kneeling on a wooden back deck, writing on a clipboard beside a weathered patio door with peeling white paint on a stucco house

Signs a window is ready to come out

Fog or film between the panes
The seal around the glass unit has failed and the desiccant inside is saturated. It can't be wiped away, and the insulating gas has already escaped.
Bent, pitted or cracked frames
Aluminum oxidizes and bends over decades, and low-grade vinyl can warp in strong sun. Once the frame is out of shape, the sash no longer closes tight against its seals.
Water or condensation at the sill
Puddling on the sill or stains on the drywall below usually point to blocked weeps or a failed sill seal. Left alone, that moisture works into the framing.
Drafts and dust along the sash
If new weatherstripping doesn't stop it, the frame itself has likely shifted. We check the simple cause first.
A sash that won't lock
When the frame has racked out of square, the latch no longer meets its keeper. If the cause is only a worn roller, we'll point that out instead.
Single-pane glass in a room you avoid
A west-facing bedroom that bakes every afternoon or a front room full of traffic noise is often the clearest sign of all.

How the job runs

  1. 1

    Measure and confirm

    At the in-home estimate we measure each opening in three places across and three places up and down, then use the smallest reading. We also note where code calls for tempered glass, such as next to doors, near tubs or close to the floor.

  2. 2

    Order and schedule

    Your windows are built to those measurements. Once they arrive, we call to set the install date.

  3. 3

    Remove one opening at a time

    We move furniture back, lay drop cloths and take out one old window at a time, so your home is never open to the weather for long. Old sealant and loose debris are scraped from the frame.

  4. 4

    Set, shim and seal

    The new window is set level, plumb and square, fastened through the jambs, insulated and sealed inside and out. Interior trim goes back on or new trim is fitted.

  5. 5

    Walkthrough

    We open and lock every sash with you and show you where the weeps are. If a permit was pulled, we arrange the inspection.

What moves the price of window replacement

Each quote is built from the openings in your home, so the total depends on what we find there. We price every window on its own line. That way you can see what changes if you do some now and the rest later.

Size and style
A standard slider costs less than a large picture window, a bay or a custom shape. Bigger glass also means heavier units and more labor to set.
Retrofit or full-frame
A retrofit insert keeps the stucco in place. Full-frame removal adds stucco cutting, new flashing and patch work.
Glass package
Low-E coatings, tempered glass where code requires it and obscure glass for bathrooms each change the cost of the glass unit.
What is behind the old frame
Rot or termite damage in a wood sub-frame only shows once the old window is out. If we find it, we photograph it and talk to you before doing any extra work.
Permit requirements
Whether a permit and inspection apply depends on the city and the scope, and that cost appears as its own line.

Before your new windows go in

Can I start with just a few windows and do the rest later?
Yes. Every opening is priced on its own line, so the worst ones can go first and the others can wait a season or two. Choosing the same Crystal Pacific frame style each time keeps the house looking consistent from the street.
Will you tell me if a window doesn't need a new unit?
Yes. If the problem is a worn roller, a dirty track or tired weatherstripping, we point it out and leave that window off your quote. We only recommend a new window where the frame, glass seal or sash has truly failed.
Is there a current offer?
Yes. Window replacement for only $495 per window with free installation (minimum purchase of 4 windows per order; some glass size and product restrictions apply). The in-home estimate is free, with no sales pressure or obligation.
Will you have to cut my stucco?
Usually not. Most openings take a retrofit insert that fits inside the existing frame. We only cut stucco when the old frame is too damaged to anchor to, and we tell you which openings those are at the estimate.
What happens if something gets damaged while the old windows come out?
We are bonded and insured, carrying $2 million in coverage for the work at your home. We also lay drop cloths, pad nearby furniture and take out one opening at a time, which keeps the risk low in the first place.

Find out which windows are truly worn out

A free in-home estimate puts us at each window with a tape measure and a flashlight. You get a written, line-item quote with no sales pressure or obligation.